20%DISCOUNT ON ALL PRINTS

 

 

As a young company we strongly believe that the future is in your hands. We all know though that living on a student budget is not easy, not at all. That's why we've decided to offer you a 20% discount on all our prints to get you off the ground. Engineering, product design, fashion, architecture and many more, 3D printing can kickstart your project and, more important, your future career.

 

SO, NOW THAT WE'RE DONE WITH THE INSPIRATIONAL BIT, HOW DO YOU APPLY FOR YOUR DISCOUNT? EASY!

Before uploading your model through the Website contact us with this form using an email address from your institution or upload a student ID (use the word IMASTUDENT in the subject field). Wait for our confirmation e-mail and voila', you can enjoy your preferential rates. Psssst, have a look at our suggestions below before leaving.


HERE ARE SOME TIPS FOR YOU

 
student-discount-design.jpg
 

QUICK DESIGN GUIDE

When designing for 3D printing always keep in mind the following guidelines:

  • WALL THICKNESS at least 1 mm.
  • CLEARANCES at least 0.25 mm.
  • PINS & COLUMNS minimum diameter 3 mm.
  • OVERHANGS try to avoid unsupported features over 45 degrees.
  • ORIENTATION when orienting your print  keep in mind areas that will need support and always have a flat and large enough surface to get your model sticking on the print bed.

For more info check out our good to know section.

 
Impeller small.jpg

MATERIALS

The material you choose will depend on how your model is going to be used. We recommend:

ABS PLASTIC for simple prototypes, clips and small casings.

ENGINEERING PLASTIC this is by far our favorite material to work with, strong and durable with a beautiful semi matte finish it's perfect for all your prototyping, showcase and end user applications.

PC ABS for the toughest applications, resistant to UV, impacts, high temperatures and chemicals, perfect for models exposed to the weather and workshop environments.

 

 
student-discount-timing.jpg

DEADLINES

This is especially important for your final projects, don't wait for the last minute, try to get the file to us asap so we can process it and get it ready for shipping before the deadline. Remember, additive manufacturing was born for prototyping, you need to leave some room to go back to the drawing board if necessary.